Инструкция, руководство для оператора экскаватора ZX200-350

Категория: Инструкции,руководства пользователя для спец техники

STORAGE10-2REMOVING THE MACHINE FROM STORAGECAUTION: Start the engine ONLY in a well-ventilated place.1. Remove grease from the cylinder rods if coated.2. Adjust alternator and fan belt tension.3. Fill the fuel tank. Bleed air from the fuel system. Check all fluid levels.4. Start the engine. Run the engine at half speed for several minutes before full load operation.5. Cycle all hydraulic functions several times.6. Carefully check all systems before operating the machine at full load.NOTE: When the machine has been stored for a long time, be sure to perform the following steps as well:(a) Check condition of all hoses and connections.(b) Warm up the engine.(c) Stop the engine.(d) Install new fuel filters. Replace the engine oil filter and fill the engine with oil.IMPORTANT: If the machine has not been used for a long time, oil films on sliding surfaces may have broken down. Cycling hydraulic functions for travel, swing and digging two to three times is necessary to lubricate the sliding surfaces.

Onlinemanuals.ru

Загрузить инструкцию